Radiant Panel Heaters

We use the highest quality components available to manufacture a heater that
will have a long life.
Manufactured to your spcifications.
E-Z clean black glass/ceramic radiation surface.
Radiation surface temperatures to 1200 degrees F.
Can withstand minor impact without damage.
Will heat all colors equally well.
Very uniform heat.
Industrial quality aluminized steel case.
Slimline 3" thick design
1/4 -20 weld nuts or 1/4-20 x 1" weld studs for mounting.
2 x 4 J-box with 12" of high temp lead wires.
Max width 24".
Max length 60".
Elements run in the direction of heater length.
Available in 120-480 volt / single or three phase.
Wattages from 5 to 20 watts per square inch.
Heat up time of 5-10 minutes

In our heaters we use quality components to help the heater have a long life.
Manufactured to your specifications.
The Series RP-SA have holes between the elements and blowers on the back
of the heater for air flow through the heater.
A unique RPI serpentine element design.
Fast responding
Heat up time of 25 seconds from cold start
Cool down to a safe temperature zone in 25 seconds. (Series RP-SA cool
faster)
Watt densities up to 50 watts per square inch.
Element temperature up to 2100 degrees F.
120-480 volt configurations within design limitations
Very solid 1/8" thick extruded aluminum case.
Stainless steel protective face screen.
1/4-20 x 1" bolts or 1/4-20 tapped holes for mounting.
2 x 4 J-box with 12" of high temp lead wires.
Heater thickness 3.75" or with protective face screen 4.75".
Max width 24 inches.
Max length 16 feet.
In plant repairability.
When controlled and used properly these heaters will have a long operating life.

In our heaters we use quality components to help the heater have a long life.
Manufactured to your specifications.
Special low mass corrugated metallic elements.
Very fast responding.
Heat up time of 10-15 seconds from a cold start.
Cool down to a safe temperature in 10-15 seconds.
Watt densities up to 50 watts per square inch.
Element temperatures up to 1600 degrees F.
120-480 volt configurations within design limitations.
Very rigid 1/8" thick extruded aluminum case.
Stainless steel protective face screen.
1/4-20 x 1" bolts or 1/4-20 tapped holes for mounting.
2 x 4 J-box with 12" of high temp lead wires.
Heater thickness 3.75" or with protective face screen 4.75".
Max width 24 inches.
Max length 16 feet.
In plant repairability.
When controlled and used properly these heaters will have a long operating life.